AAI Galvanised Mild Steel Stairs - Type AA730

Galvanised Mild Steel Stairs

Galvanised Mild Steel Stairs

AA730 galvanised mild steel stairs are provided in accordance with BS EN ISO 14122 & BS 5395, which should be consulted during the design of any single / multi flight stairs.

General Considerations:

Individual stair flights should not exceed 3000mm rise between floor or landing levels, nor contain more than 16 risers. The preferred stair pitch is from 30 to 38o, although for a private stairs up to approx. 42o is acceptable.

Handrails to the stair flight should be between 900mm and 1000mm high from the pitch line, with handrails to landings 1100mm min – both cases complete with intermediate rails.

Treads and risers should be pitched such to afford comfortable gait – please refer to the table in BS 5395, however approx. 250mm going and 190mm rise is typical.

For stairs with open risers, the nosing of any tread or landing should overlap the back of the tread below by not less that 16mm.

Assembly stairs exceeding 36 risers in consecutive flights, should have at least on change of direction between flights, (min 30o).

Headroom, (vertical distance from FFL), over stairs and landings should not be less than 2000mm with a clearance, (distance perpendicular to the pitch line) of at least 1500mm. For stairs of 3 steps of less this should be increased.

Materials:

Stringers: Generally flat bar, or channel section.

Handrails: Generally as per AAI700 series, although welded handrail or balustrade is available if required / specified.

Flooring and Treads: Generally per AAI710 series, although chequer / solid plate treads are available if required / specified.

Finish: Galvanised to BS EN ISO1461.

Our team of highly experienced staff are here to design, project manage, manufacture and install Galvanised Mild Steel Stairs
Contact us for help and assistance